5th May 2014

More Wiring

Hours: 6.0 | Posted in Avionics, Foward Fuselage

I’ve done about as much as I can on the stack on the work bench, so I moved it over to the wiring jig.
The area above the radio stack is where the DVR will go and the area below the radio stack is where the NUC computer will be. To the right is the high brightness MFD monitor. There will be a black bezel surrounding the stack, matching the EFIS bezel.



Power is not yet connected into the VP-X but is still common on the main bus. I connected everything up and tested COM1 with a friend using 123.45. COM1 (VAL COM 2000) sounded good, maybe side tone is a little high but need serial port to adjust that.


Comments are closed.